Command MCONNECT

To quickly create many RTP connections please use the following command:

MCONNECT <num_of_conn> rtp:<src_ip>:<src_remote_port+shift>:<src_local_port+shift>:[src_codec] rtp:<dst_ip>:<dst_remote_port+shift>:<dst_local_port+shift>:[dst_codec]

The abbreviations are:

• num_of_conn: number of connections
• src_ip, dst_ip: source/destination IP-address
• src_remote_port, dst_remote_port: source/destination remote port number
• src_local_port, dst_local_port: source/destination local port number
• shift: port’s shift
• src_codec: source/destination voice codec used for the specified stream end, e.g. alaw (or g711a), ulaw (or g711u), g723, g726, g729.

Note:
You can use this command only in the case of RtpBridge commands run from a configuration file.
If src_codec and dst_codec parameters are not specified, they take the default value. Currently the default codec is alaw.
For the incoming RTP data src_codec can be overridden by the payload type of RTP packet.

Example:

mconnect 31 rtp:192.168.102.90:8002+4:7002+4:alaw rtp:192.168.102.90:8002+4:9006+4:g729 

(Creates 31 connections)